沖擊臺 Shock Tester
一、相關標準測試要求 Test requirements
1.IEC62133-2012
2.UL1642
3.UN38.3
4.GB31241-2014
沖擊臺 Shock Tester 一、相關標準測試要求 Test requirements 1.IEC62133-2012 2.UL1642 3.UN38.3 4.GB31241-2014 二、主要技術參數 Main Technical Parameters二、主要技術參數 Main Technical Parameters
型號 Model |
BE-IS200 |
|
額定負載 Specified load |
10 kg(含夾具、試驗件)fixtures, test pieces are included |
|
臺面尺寸(長×寬) Bench Dimension |
200×200 mm |
|
沖擊波形Pulse Wave: |
半正弦波Half sinusoidal wave |
|
峰值加速度(半正弦波) Shock Impact Peak Acceleration |
150~15000 m/s2 |
|
脈沖持續時間(半正弦波) Pulse Duration Time: |
0.6~20ms |
|
外形尺寸(長×寬×高) External Dimension |
1000mm×500mm×2700mm |
|
設備重量 Weight |
1500 kg |
|
沖擊形式Impact form |
自由跌落Free fall |
|
最大跌落高度Max. drop height |
1500mm |
|
電 源 Power Supply |
三相380V,50/60 Hz Three phase 380V,50/60 Hz |
|
液壓源Hydraulic source |
隨機配置 With the equipment |
|
環境條件 |
溫度(℃)Temperature |
0~40 |
Condition |
濕度(25℃)Humidity |
<85% |
可靠性 reliability |
平均無故障積累工作時間≥1000h; Average failure-free accumulation working time ≥ 1000h; 半正弦波形發生器連續沖擊次數不小于5000次; The half-sine waveform generator has no less than 5000 consecutive impacts; 半正弦波形發生器的在干凈、常溫環境下的存儲時間不小于5年。 The half-sine waveform generators have a storage time of no less than 5 years in a clean, room temperature environment. |
|
測控系統 Testing system |
ShockDAQ沖擊、碰撞測量控制系統 Impact, collision measurement control system |
|
適用標準 Usage standard |
GJB150、GJB360、GJB548、GB/T2423、GJB1217、JJG497、GIEC68-2-27 |
|
檢定標準 Testing standard |
加速度幅值、脈寬、均勻度和橫向運動比滿足JJG541-88的要求。 Acceleration amplitude, pulse width, uniformity, and lateral motion ratio meet the requirements of JJG541-88. |